The expression pedals on my Behringer FCB1010 MIDI foot controller don’t work properly in Programming mode.

Advertisements

It is likely that the pedals need calibrated. Follow the steps below to calibrate the expression pedals on your Behringer FCB1010:

  1. Turn on the FCB1010 while holding footswitches 1 and 3. When the display goes blank, release the switches. The FCB1010 will light up in sequence.
  2. Once all the lights are on, press each Footswitch one at a time, including the UP and DOWN switches, until all the LEDs turn off. You will hear some mechanical clicks, and then the display will read “F1.”
  3. Press the DOWN switch once.
  4. Adjust the left expression pedal (A) to the lowest value (heel down), then press UP.
  5. Now adjust expression pedal (A) to the highest value (toe down), then press UP.
  6. Next, adjust the right expression pedal (B) to the lowest value (heel down), then press UP.
  7. Finally, adjust expression pedal (B) to the highest value (toe down), then press up.
  8. Reboot the unit.
Advertisements

Originally published by

http://www.sweetwater.com

Categories: Technology

Tagged as: ,

2 replies »

  1. My expression pedals don’t seem to work why when I have tried everything and when I try to calibrate them all I see is letters not numbers and I put a updated chip a 2.5 what’s the problem

    Like

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s